Skip to content
← All FAQs

How do you reset a water heater when it stops working?

Resetting a water heater usually means restoring power and pressing the unit’s safety reset button after fixing the cause of the trip. The most common cause is a tripped breaker or overheated thermostat on electric units, and an extinguished pilot or control lockout on gas or tankless models. Our plumbers handle these issues safely across the Treasure Valley, including Nampa.

Try these steps in order:

  • Electric: turn off the breaker, open the upper access panel, press the red reset/high‑limit button, close the panel, then restore power.
  • Gas tank: follow the lighting/reset instructions on the unit label to relight the pilot or clear lockout.
  • Tankless: power cycle the unit, note any error code, then perform the panel’s reset.
  • If the breaker trips again or the reset pops immediately, stop and schedule service.
  • Do not reset if you smell gas, see active leaking, or water is scalding.

If you’re unsure of the steps or the heater keeps shutting off, stop and have a licensed plumber diagnose the fault.

Updated: 2026-11-11

Need help in Nampa, ID? Call (208) 378-6624 or book online. “Jake and Nickolas did a very neat installation of a water heater and the associated plumbing.” — Ron Reese

Sources8

Source links open in a new tab.

Still Have Questions?

Our experienced team is here to answer your questions and help you find the right solution.

Call nowSchedule service